Micro-screws for Bone Grafts from OMNIA

Micro-screws are used for small autologous and heterologous bone graft. The Micro screw are self-tapping and made from low profile titanium alloy with a Ø1.5 and a Ø3 mm head designed specifically to engage inner square tips which guarantees excellent stability of the Micro screws minimizing the risk of them freeing themselves during application phase.

Advantages:

  • Cylindrical head screw
  • Self-threading
  • Chamfered profile head
  • Inner square insert for firm grip and safe screwing/unscrewingMicro-screws for Bone Grafts from OMNIA
  • New better performing tip, greater cortical penetration

Micro screws are delivered in a handy sterilizable blister pack
making the management of micro screws easier, from storage and conservation to their clinical application. Each blister pack is sterile and contains 5 micro screws.

A Micro screw is disposable and cannot be reused, as this could cause the onset of infections or results in the failure to maintain the technical features.

Sterilization
Micro screws are supplied in sterile conditions (sterilization by Ethylene Oxide); this condition is ensured when the box is undamaged. If the box is damaged or there is partial use of micro screws contained in the rigid support, the specialist can re-sterilize the same following these steps:

  • Pack the rigid support with the Micro screws which are still unused (Warning: the used Micro screws must be eliminated – risk of infection) in an envelope (medical paper).
  • Sterilize with steam in an autoclave at 121°C for 15 minutes or 134°C for 10 minutes.

Micro screws box is composed of:

  • Blister pack containing 5 titanium micro-screws
  • Handle for screwdriver LM1 in titanium
  • Screwdriver tip for Handle LM1, inner square in titanium
  • Screwdriver for contra-angle handpiece, inner square in titanium
  • Guide drill Ø 1.1 x 3.5 mm for membrane or mesh
  • 1 Guide drill Ø 1.1 x 7 mm for microplates
  • 1 Guide drill Ø 1.1 x 9 mm for bone block
  • 1 Guide drill Ø 1.1 x 15 mm for bone block
  • 1 Guide drill Ø 1.5 x 15 mm for drilling pilot holes into the bone block, without causing fractures while screwing the micro screws Ø 1.5

Micro-screws for Bone Grafts from OMNIA

Size:

  • 5 microscrews Ø 1,5 x 3 mm
  • 5 microscrews Ø 1,5 x 4 mm
  • 5 microscrews Ø 1,5 x 5 mm
  • 5 microscrews Ø 1,5 x 6 mm
  • 5 microscrews Ø 1,5 x 7 mm
  • 5 microscrews Ø 1,5 x 8 mm
  • 5 microscrews Ø 1,5 x 9 mm
  • 5 microscrews Ø 1,5 x 11 mm
  • 5 microscrews Ø 1,5 x 13 mm
  • 5 microscrews Ø 1,5 x 15 mm


Leave a Reply

Your email address will not be published. Required fields are marked *

*

*